 |
Technically speaking, the Robin Memorial appears three different ways over the course of the various animated series: as above in "Over the Edge," the red and black version in "Sins of the Father," and of course the full Heroes Memorial in "Batman Beyond." This time around, I chose to go with the "Over the Edge" version, as I think it's visually the most interesting. Robin's case is a figure case intended for a Star Wars figure. Clear acetate (in this case, clear presentation covers from an office supply store) was used to "hang" the costume. The case was measured from the inside, then the appropriately sized piece of acetate was cut. An eighth of an inch was allowed at the top, to be scored, folded and ultimately glued to the top of the interior of the case. Robin's costume was printed and cut with an X-acto blade. Spray adhesive was applied to the back, then the cut out was applied to the already cut acetate. Having already scored and folded the top 1/8", standard model glue was applied to the top of the acetate. (DO NOT use Super Glue! It creates a chemical reaction that will "cloud" your acetate.) Using a pen or similar narrow instrument, firmly apply the glue-bearing top of the acetate to the top of the case. (This is easiest when all the parts in question are upside-down.) Casimir |
|
|
|
Each Memorial is now offered as a free download for your use. Feel free to use each one to build a better Batcave! Each has been appropriately sized at 300 dpi to fit inside the cases as described above. Right click and use "Save Target As" on the link below, then open and print from an appropriate imaging program. If you try to print these directly from your browser, they will be far too large. You have been warned! Note: By downloading and using these, you agree each will be used only for personal use, and not reselling. Difficulty: |
|
